Hi everybody,
Now i have a USRP board and a XCVR2450 daughterboard, i have installed
gnuradio-3.1.3 on FC9 sucessfully.
But i can not find XCVR2450 in the usrp_dbid.dat. I wonder if i add
“XCVR2450 Tx” 0x0060
“XCVR2450 Rx” 0x0061 in the usrp_dbid.dat and run
gen_usrp_dbid.py to
generate the new usrp_dbid.py, dose the XCVR2450 daughterboard can work
well?
Whether the XCVR2450 can not work on GNURadio3.1.3?
Any answer will be appreciate!
Best regards!
On Fri, Dec 12, 2008 at 9:32 PM, e$BF!D6e(B [email protected] wrote:
Now i have a USRP board and a XCVR2450 daughterboard, i have installed
gnuradio-3.1.3 on FC9 sucessfully.
But i can not find XCVR2450 in the usrp_dbid.dat. I wonder if i add
“XCVR2450 Tx” 0x0060
“XCVR2450 Rx” 0x0061 in the usrp_dbid.dat and run gen_usrp_dbid.py to
generate the new usrp_dbid.py, dose the XCVR2450 daughterboard can work
well?
Whether the XCVR2450 can not work on GNURadio3.1.3?
Yes, this should work. You’ll need re-run the build afterwards to
re-install for it to take effect.
This change is pending in release 3.1.4 as well.
-Johnathan