On Tuesday 27 October 2009 22:56:04 tom_unaff wrote:
Hello,
I do IQ plotting for DBPSK, DQPSK, 8PSK. (Please have a look below):
For DBPSK:
http://omploader.org/vMm16Zg/dbpsk_IQ_plotting.png
For QPSK:
http://omploader.org/vMm16Zw/dqpsk_IQ_plotting.png
Can someone explain why for DQPSK positions of ideal points are wrong? It
should be [1,1], [-1,1],[-1,-1],[1,-1]
Welcome to the real world, you just swallowed the blue pill 
Radio signals are subject to
- attenuation (signal gets weaker when moving tx/rx apart)
- gains from antennaes, PAs (power amplifier) on tx, low noise
amplifiers on
rx side
- multipathing
- frequency deviation (doppler shift, oscillator mismatch between rx/tx)
- deviation in symbol timing (rx samples e.g. 2.001 symbols while tx is
only
sending 2.0 - after 1000 symbols, you are off one symbol)
- ambient noise and interferers
There are several signal processing blocks which deal with this
problems, e.g.
AGC (automatic gain control) for attenuation, carrier recovery for
frequency
deviation. These blocks mitigate the effects, but only to some extent.
You seem to have some of these blocks in you flowgraph already,
otherwise you
would get something looking quite diferrent.
For dqpsk, you have your ideal positions with a seemingly constant phase
offset, and some additional white noise.
For white noise: Try to have a stronger signal at the receiver. The
ambient
noise level is given for your current environment, but you can: Use
antennaes
with higher directionality, increase the tx power level.
For phase offset: Have a look at the combined carrier/symbol timing
recovery
block gr_mpsk_receiver. Google for Costas and Mueller&Müller for the
algorithms implemented there.
Also for DBPSK, Why symbols on right site (of Y-axis ) are far away from
point, [1,0]? How to fix it?
Difficult to say. This is a DC offset, and it should be dealt with in
the
USRP. Unfortunately, you did not give any information about your
flowgraph,
so you are on your own here …
In general: get a good book about analog and digital transmission
systems. It
is impossible to build a rx/tx system without a good understanding of
the
existing problems and how to deal with them.
Stefan
–
Stefan
BrünsDepartment of Wireless Networks, RWTH Aachen University
+49 2407 575-7045
