USRP2 with WBX and LP0926 to receive GSM spectrum

GNU Radio
1

Hi
We have received USRP2 with WBX and LP0926 PCB Antenna on 19
August,2010.
We are trying to receive GSM spectrum ( Above 900MHz) but we are getting
the error USRP2: Channel 0 not receiving
USRP2: rx_samples(0 failed.
Â
When we run the command sudo usrp2_fft.py -f 900M , we are getting the
same error.
Below 900MHz, the above mentioned command is working ( we are able to
see the spectrum).
Would you please guide us what the reason for error.
Â
Best Regards
Â
Zimran Rafique

2

On 10/05/2010 04:30 PM, hafiz zimran wrote:

Would you please guide us what the reason for error.
Discuss-gnuradio mailing list
[email protected]
Discuss-gnuradio Info Page

Are you running the as-shipped firmware? If so, it doesn’t support the
WBX. You’ll need to go
here, and get the appropriate firmware and fpga load:

http://code.ettus.com/redmine/ettus/projects/public/wiki/U2binaries