I am facing an issue with an USRP2 with a RFX2400 daughterboard. I have
observed that when the USRP2 is used for transmission/reception, it
transmits/receives the first few packets successfully and then just
dies. When this happens, its transmitted packets are not received by
and it itself cannot receive packets anymore. The other USRP2s’ run my
program successfully. I have checked the flow control settings and they
are ok. If
the USRP2 is rebooted, the same cycle repeats. However, find_usrps and
usrp2_fft.py work fine. This problem is impeding progress in my work.
Any help in this regard will be appreciated.
University at Buffalo