Discuss-gnuradio mailing list
[email protected]
http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
On Sat, Mar 19, 2011 at 06:18:18PM -0500, Ricky A. Melgares wrote:
The output from serial is most interesting, because the eth link speed
changes to 1000 and then to 0 immediately after roughly every 3
seconds.
Hey, Ricky. This behavior is typical of gigabit ethernet with a bad
cable or other physical layer problem. Have you swapped the cable?
Make sure you are using a cable with eight conductors, not just four.
Have you tested the laptop with a gigabit switch? Have you tested the
USRP2 with another host? I recommend checking the jacks to make sure
they don’t have any bent pins.
Discuss-gnuradio mailing list
[email protected]
http://lists.gnu.org/mailman/listinfo/discuss-gnuradio