Hy, I’m Massimo and I’m a Italian student. I have some problem with
USRP2 blockset of Simulink. When I run the simulation of the “demo”
example in Simulink, is shown me the following error:
"Board did not reply to a host query or configuration. Cannot run
simulation. Please ensure you have a connection by opening the block
mask and examining the Hardware section. "
I followed exactly the instructions on the following link:
http://www.mathworks.com/help/toolbox/commblks/ref/usrp2receiver.html,
including Technical solution 1-CUN7JZ and 1-D2KBPZ. I update the
firmware and the FPGA on the SD card from the as suggested, but the
result has not changed. Can anyone tell me where am I wrong? Sorry for
my english.
Best regards, Massimo.