I saw your message about modifying the DBSRX to work with the USRP2 and
just wanted to confirm and ask a couple of other questions.

The two steps are:

  1. Put the DBSRX into a USRP1 on Side A, connect to a computer and run:

burn-db-eeprom -A --force -t dbsrx2

  1. Remove R193 (on the underside of the DBSRX) and move it to R194 which
    is empty.

Does this then make this DBSRX unusable with a USRP1? And if so how
would I switch it back?

Thanks very much,


On Tue, Jul 28, 2009 at 11:49, Kelley, Clifford
W[email protected] wrote:

   burn-db-eeprom -A --force -t dbsrx2

I think it is ‘dbsrx_clkmod’, not ‘dbsrx2’:


This forum is not affiliated to the Ruby language, Ruby on Rails framework, nor any Ruby applications discussed here.

| Privacy Policy | Terms of Service | Remote Ruby Jobs