Dear all,
My USRP has been working great until recently. Today, I tried testing
with
usrp_benchmark.py and got this, but not always. I tested it with
gnuradio 3.1.3
and gnuradio 3.2.2 and got the same results.
Testing 2MB/sec… usrp_open_interface:usb_set_alt_interface: failed
could not set alt intf 0/0: Protocol error
open_nth_cmd_interface: open_cmd_interface failed
usrp: failed to load firmware /usr/local/share/usrp/rev4/std.ihx.
Traceback (most recent call last):
File “usrp_benchmark_usb.py”, line 106, in
main ()
File “usrp_benchmark_usb.py”, line 96, in main
ok = run_test (rate, verbose)
File “usrp_benchmark_usb.py”, line 63, in run_test
usrp_tx = usrp.sink_s (0, tx_interp)
File “/usr/local/lib/python2.5/site-packages/gnuradio/usrp.py”, line
232,
in init
fpga_filename, firmware_filename)
File “/usr/local/lib/python2.5/site-packages/gnuradio/usrp1.py”, line
946,
in sink_s
return _usrp1.sink_s(*args)
RuntimeError: can’t open usrp1
The boards still blink, sometimes when I power it on it doesn’t blink,
sometimes after a while both leds are steady.
I would appreciate any hints to find out if I accidentally damage it.
Regards,