Using Matlab/Simulink with GNU Radio and USRP2

GNU Radio
1

Hi,
Are there any tutorials or guides on how to use Matlab/Simulink
with GNU Radio and USRP2?

There is an RF blockset in Simulink, and it also has the ability to
integrate with the Xilinx ISE 12.1 System Generator tool.

Using these tools, one should be able to model using Simulink and export
signal processing blocks to the FPGA or generate C code.

Best regards,

Elvis D.

2

Hi Elvis,

What I recall from a presentation Ettus gave was that you can integrate
matlab with the USRP2; you have to write the drivers for the
matlab/USRP2
interface. So it is possible.

I don’t have any further details, sorry. Maybe try looking for driver
tutorials for matlab?

–Colby

3

Hi,

On Jun 18, 2010, at 10:26 PM, Colby B. wrote:

What I recall from a presentation Ettus gave was that you can integrate matlab with the USRP2; you have to write the drivers for the matlab/USRP2 interface. So it is possible.

Are there any source code examples for USRP1 ? I need to have an idea of
where to start and how to interface USRP2 and to control it.

Best regards,

Elvis

4

On Fri, Jun 18, 2010 at 4:08 PM, Elvis D. [email protected]
wrote:

Hi,

On Jun 18, 2010, at 10:26 PM, Colby B. wrote:

What I recall from a presentation Ettus gave was that you can integrate matlab with the USRP2; you have to write the drivers for the matlab/USRP2 interface. So it is possible.

Are there any source code examples for USRP1 ? I need to have an idea of where to start and how to interface USRP2 and to control it.

I’m assuming you’ve seen this:

http://www.cel.kit.edu/downloads.php

–
John O.
CEO/System Architect
Epiq Solutions