Updated GNU Radio on Beagleboard (and other OMAP platforms like USRP-E100)

GNU Radio
1

I updated the page for build GNU Radio on the BeagleBoard:

http://www.opensdr.com/node/17

Basically, the image builder can make images with the toolchain and UHD
now.

The Angstrom image builder also has support for the USRP-E100 now.
Problems with images from the online image builder should be reported to
the Angstrom developers.

Philip

2

I have two USRP1 boxes and four RFX2400 daughter cards. It looks that
one
of the two USRP1 box does not recognize three of four daughter cards.
I pluged in the daughter card to a USRP1 one by one and ran
benchmarck_tx.py script with the center frequency set to 2.4G. All four
daughter cards ran ok on one chassis. However, one the other chassis, an
error came out saying it failed to tune to 2.4G on three out of four
cards.
If I insert one “accepted” card and one not accepted card on this bad
USRP, the error message goes away.

Could you let me know if you have any clue?
Thanks,

Thomas