Up conversion on USRP2 questions

Community,

I’ve read all the faq and a lot of code (some codes i couldn’t
understand, I learning c++ and verilog yet…) about USRP2, but I
also have doubts.
They are,

1 - Is the DUC fully implemented in FPGA?
2 - Is the “complex modulation function”[page 38, AD9777 datasheet]
used?
3- The function “set_tx_center_freq()” sets the carrier frequency as
tune() function does on usrp1, right?

Thanks for all,


Ronaldo A. Viera Nunez
Acadêmico/Engenharia Elétrica
Universidade Federal de Santa Maria

Santa Maria - RS - Brasil

Ronaldo N. wrote:

Community,

I’ve read all the faq and a lot of code (some codes i couldn’t
understand, I learning c++ and verilog yet…) about USRP2, but I
also have doubts.
They are,

1 - Is the DUC fully implemented in FPGA?

Yes.

2 - Is the “complex modulation function”[page 38, AD9777 datasheet] used?

You can enable it if you want it, but it is disabled in the firmware
right now.

3- The function “set_tx_center_freq()” sets the carrier frequency as
tune() function does on usrp1, right?

Yes.

Matt

This forum is not affiliated to the Ruby language, Ruby on Rails framework, nor any Ruby applications discussed here.

| Privacy Policy | Terms of Service | Remote Ruby Jobs