Hello All
A while ago my advisor showed how to use the USRP2, yesterday I
connected it to my laptop and the USRP2 booted up (LED D&F came on) but
the Ethernet connection did not respond.
I tried to connect a serial to USB cable to the Debug port and there I
got the correct Rx/Tx Card ID’s and the correct MAC address but when I
connected the Ethernet cable I got
eth link changed: speed 0
and the LEDs on the Ethernet connector stays dark.
The computer that is connected to the USRP2 jumps between “network
connected” and network Disconnected at irregular intervals…
I have tried to debug it using Fireshark -but I couldn’t see any traffic
there.
running “ethtool eth0” I get the following result
Settings for eth0:
Supported ports: [ TP ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Full
Supports auto-negotiation: Yes
Advertised link modes: 1000baseT/Full
Advertised pause frame use: No
Advertised auto-negotiation: Yes
Speed: Unknown!
Duplex: Unknown! (255)
Port: Twisted Pair
PHYAD: 2
Transceiver: internal
Auto-negotiation: on
MDI-X: Unknown
Supports Wake-on: pumbag
Wake-on: g
Current message level: 0x00000001 (1)
Link detected: no
Any ideas of what can be the issue?
(I have seen that particular USRP2 work earlier so I can’t understand
why it refuses to work now)
Best regards
/Oscar