Switching between TX and RX on XCVR2450

Hi,

I wonder if it is possible to switch between TX and RX on XCVR2450 using
GRC
(in the same workflow).
If not, what is the easiest way to achieve it?

I would like to build an application that transmits a signal and then
switchs to reception. Afterwards it has to switch to TX again and so on.

Many thanks,
Jorge.

Hi Kuntal,

Im afraid the XCVR2450 does not allow full duplex working mode. So I
need
to enable tx, then disable transmission and enable reception.

Is it possible in GRC?
If not…how is it possible?

Many thanks!
Jorge.

This forum is not affiliated to the Ruby language, Ruby on Rails framework, nor any Ruby applications discussed here.

| Privacy Policy | Terms of Service | Remote Ruby Jobs