Stand-alone USRP2: Modifying FPGA design


#1

Hi, all.

I plan a stand-alone USRP2 transmitter (without using PC).
So, it is required to modify the Spartan3 ISE project(s) and add some
HDL source codes for the transmitter.
However, there are many sub-blocks in the project(s) so that it is hard
to figure out that which block should be modified.
It would be very helpful for me if anyone could notify that which part
(or block) should be modified.

Thanks.


#2

On Mon, Dec 29, 2008 at 1:24 AM, Yongsang K. removed_email_address@domain.invalid
wrote:

Hi, all.

I plan a stand-alone USRP2 transmitter (without using PC).
So, it is required to modify the Spartan3 ISE project(s) and add some
HDL source codes for the transmitter.
However, there are many sub-blocks in the project(s) so that it is hard
to figure out that which block should be modified.
It would be very helpful for me if anyone could notify that which part
(or block) should be modified.

There is a port that feeds the interpolation DSP chain.

If you’re making a transmitter, this is probably where you want to
feed the samples you create.

Brian