Hi,
Doe the USRP2 require specific FPGA and firmware contents to interface
with simulink? When I turn on the USRP2 with the SD card in, all 6 leds
flash and then D and F stay on. Does this mean my SD card is properly
programmed with the correct content?
Thanks!
-Camden Mendiola
Hi,
Doe the USRP2 require specific FPGA and firmware contents to interface with
simulink? When I turn on the USRP2 with the SD card in, all 6 leds flash and then
D and F stay on. Does this mean my SD card is properly programmed with the correct
content?
Thanks!
-Camden Mendiola
This is totally the wrong list for this type of question, since SimuLink
requires special firmware and FPGA images.
You should post your question on usrp-users, or talk to the SimuLink
folks.
http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com
–
Marcus L.
Principal Investigator
Shirleys Bay Radio Astronomy Consortium
http://www.mathworks.com/support/solutions/en/data/1-D2KBPZ/index.html?solution=1-D2KBPZ
The above information mentions some UDP firmware, I was under the impression
that you could use the USRP2 UHD drivers and firmware located here, with Simulink:
http://www.ettus.com/downloads/uhd_releases/003_001_000/images-only/
Elvis D.
Unless the Mathworks folks have very recently updated their “stuff” to
use UHD, you can’t use the UHD images for Simulink. Simulink
used (and continues to, as far as I know) a firmware/FPGA image that
used UDP encapsulation, but it’s totally incompatible with
UHD–it was very “beta” and that line of development was never
maintained, but that’s what the SimuLink people standardized on.
–
Marcus L.
Principal Investigator
Shirleys Bay Radio Astronomy Consortium
On Tue, May 24, 2011 at 3:57 PM, Camden Mendiola
[email protected]wrote:
Hi,
Doe the USRP2 require specific FPGA and firmware contents to interface with
simulink? When I turn on the USRP2 with the SD card in, all 6 leds flash and
then D and F stay on. Does this mean my SD card is properly programmed with
the correct content?
http://www.ettus.com/uhd_docs/manual/html/usrp2.html#front-panel-leds