Hi
I am new to gnuradio. I have done installation of uhd and
gnuradio form buildgnuradio script successfully. Now I want to receive
900MHz signal from USRP1. when i run uhd_fft… it does not give any
significant result. and when i run usrp_wfm_rcv_pll.py it does not
receive any signal
Its terminal output is:
usama@usama-Inspiron-N5110:~$ cd …
usama@usama-Inspiron-N5110:/home$ cd …
usama@usama-Inspiron-N5110:/$ cd usr/local/share/gnuradio/examples/uhd
usama@usama-Inspiron-N5110:/usr/local/share/gnuradio/examples/uhd$ sudo
python usrp_wfm_rcv_pll.py -f 900M
[sudo] password for usama:
linux; GNU C++ version 4.6.3; Boost_104800;
UHD_003.007.000-123-g87b068ed
– Opening a USRP1 device…
– Using FPGA clock rate of 64.000000MHz…
Using Volk machine: avx_32_mmx_orc
FYI: This implementation of the stereo_carrier_pll_recovery has no
squelch implementation yet
FYI: No Powermate or Contour Knob found
Radio does not support required frequency range.
-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1
Hi usama,
The USRP1 is the platform. You use it with an RF front end, the
so-called daughterboard.
Radio does not support required frequency range.
Tells us that the daughterboard you use does not support the center
frequency of 900MHz.
Greetings,
Marcus
On 13.04.2014 12:58, ??? ??? wrote:
Its terminal output is:
_______________________________________________ Discuss-gnuradio
mailing list [email protected]
Discuss-gnuradio Info Page
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1
Comment: Using GnuPG with Thunderbird - http://www.enigmail.net/
iQEcBAEBAgAGBQJTSndQAAoJEBQ6EdjyzlHtC8cH/0y39DlDlmCup6zZp06KRBj4
y1HiM5W0UPSrGW0wr0TAT+suG/CPL5nm6MYt9U315Mu9YVw1fc7vkYWmxZlc29Q2
9BQZwCE2kD+uMTQ+xEQZpUa+cZPvcIcv8UotjVDK6oJ00doGBiDDRn8DSYFJ0jtD
cQ8mxZ2evPb/Z9zJwhVNSnNpJjLgUJ2eOKmVnD9yBwQ9qQf/5lU3imGgbMf9EnC5
7MtzFpnfgMaFWJ+RmxNaFZdk27aaK70L6PF5jj3UeLZO3SlV/vkLkZ1PTz/TBHpy
hXdHXZiiBFH12dz8l/rb+RJJY5wSxmg5QibaTPYOQuzX+LQMTAastrUh+Zy4Gfg=
=bFNQ
-----END PGP SIGNATURE-----