Re: USRP with USB/IP


#1

Hi,

— On Sat, 6/6/09, Alberto T. removed_email_address@domain.invalid wrote:

Patrick

From the web site the transfer rate of these boxes is 10/100Mb/s. So theoretically it should transfer a maximum of 12.5MByte/sec which is far below the required 32Mbyte/sec of USRP1.

Hello Firas.

Just for my understanding:
The 32Mbyte/s requirement is for a full speed - 4 channel USRP operation.

NO.

But if we suppose a simpler application, e.g. 1 TX/RX
channel only, wouldn’t this fit in the USB/IP?

The 32MB/s is required for 1,2 and 4 channels. For 1 Channel when you
sustain 32MB/s, this means that your dealing with 8M complex samples.
For 2 channels, this means that you are dealing with 4M complex samples
for each channel, …etc.

Thanks
for your reply.
BR
Alberto

Best Regards,

Firas