Hi Josh,
Sorry, didn’t see your e-mail until getting the digest today. Thanks for
the fix!
Cheers,
Adam
A fix has been pushed (the eeprom offset was wrong). -Josh
On 11/16/2010 08:57 AM, Gregory, Adam wrote:
Hi all,
I’m trying to get a MIMO setup working using USRP2s with the UHD
drivers. I have a PC with 2 gigabit Ethernet interfaces, and a USRP2
connected to each.
My problem is that I can’t change the USRP2 IP address so that the
two
devices have different addresses. I can set the IP address in the
motherboard EEPROM using usrp_burn_mb_eeprom, and I can see the
updated
IP address reported when I run uhd_usrp_probe, but the IP address the
USRP2 answers to is still 192.168.10.2.
Power-cycling the device has no effect, nor does trying another PC in
case of any address caching. I’ve tried with UHD firmware& fpga
images
built myself from the latest git, and also with the 01/09/2010
release.
I’ve seen on the mailing list archives that some people have had
success
with MIMO and UHD, and I haven’t found any reference to IP address
problems. I must be missing something. Could anyone help please?
Thanks in advance,
Adam
–
Roke Manor Research Ltd, Romsey,
Hampshire, SO51 0ZN, United Kingdom
Part of the Chemring Group
Registered in England & Wales at:
Chemring Group PLC, Chemring House, 1500 Parkway,
Whiteley, Fareham, Hampshire PO15 7AF, ENGLAND
Registered Number: 267550
Visit our website at www.roke.co.uk
The information contained in this e-mail and any attachments is
proprietary to Roke Manor Research Ltd and must not be passed to any
third party without permission. This communication is for information
only and shall not create or change any contractual relationship.