Hi,
Thanks for your help. Unfortunately, even after I have uploaded r2 FPGA
code, I am not able to see anything on the spectrum. I have also tried
to connect antennas directly to the sma connector on the XCVR2450 board.
Both antennas are connected to J1 antenna port. I tried to send a
modulated signal at 5.5GHz and detect it using uhd_fft.py But I haven’t
seen any tone at the spectrum. Could it be a hardware problem? Do you
have any test programs that I can use to check the hardware?
Regards,
Burak Kelleci