Thanks a lot, it really got me going! This is part of my learning
if it’s leading to nothing at all; that’s okay.
Somewhere I red about feeding multiple dongles from a single signal
A possible configuration:
- Upconverter & 30 Mhz low pass filter
- Cheap wideband amplifier / splitter ( 75 Ohm tv splitter ?)
- Rig dongles with usb hubs
I fiddled around with Mike’s example had a hard time to figure out the
to merge the FFT outputs. Found the solution in the ‘Streams to Vector
block’ Setting the vector length to the FFT size.
Let’s test the frequency border(s)