Hi
Thanks for the suggestion.
I could burn the images finally after renaming the file to
u2plus_usrp_n200_r4_fpga.bin and using ./usrp_n2xx_net_burner_gui.py
–dont-check-rev
(It was showing error even with u2plus_r4.bin or u2plus_n200_r4.bin)
Amy
On 07/24/2013 12:48 PM, Amy Kumar wrote:
Hi
I made a change in the u2plus_core.v and generated a new bin file
using:
make -f Makefile.N200R4 bin
When I try burning the new FPGA image to USRP N200 R4, I get the
following
error:
‘Error: incorrect FPGA image version.Please use the correct image for
device n200_r4’
I think the revision I’ve used is correct. I don’t understand why I am
getting this error.
Any suggestions would be appreciated.
Amy
Discuss-gnuradio mailing
[email protected]://lists.gnu.org/mailman/listinfo/discuss-gnuradio
I think it just checks the filename to make sure that it ends in “_r4”.
If you’re making your own images, and using your own filenames, you
should
probably use --dont-check-rev
Here’s the --help:
Usage: usrp_n2xx_net_burner.py [options]
Options:
-h, --help show this help message and exit
–addr=ADDR USRP-N2XX device address
–fw=FW firmware image path (optional)
–fpga=FPGA fpga image path (optional)
–reset reset the device after writing
–read read to file instead of write from file
–overwrite-safe never ever use this option
–dont-check-rev disable revision checks
–list list possible network devices