Rails 1.2 with Subversion

Rails
1

I followed the instructions on how to use subversion with Rails at
http://blog.teksol.info/articles/2006/03/09/subversion-primer-for-rails-projects

Do I need to follow the instructions under the section “Using Rails
Edge and …”?

Also after I installed 1.2 RC1 the rails -v says the version 1.1.6, is
it right?

2

Bala P. wrote:

I followed the instructions on how to use subversion with Rails at
http://blog.teksol.info/articles/2006/03/09/subversion-primer-for-rails-projects

Do I need to follow the instructions under the section “Using Rails
Edge and …”?

Also after I installed 1.2 RC1 the rails -v says the version 1.1.6, is
it right?

Ony if you want to use edge rails.

And yes, RC1 has a version of 1.1.6. They will not increase that to 1.2
until it’s fully released.

3

Hi !

2006/11/27, Bala P. [email protected]:

I followed the instructions on how to use subversion with Rails at
http://blog.teksol.info/articles/2006/03/09/subversion-primer-for-rails-projects

Do I need to follow the instructions under the section “Using Rails
Edge and …”?

Also after I installed 1.2 RC1 the rails -v says the version 1.1.6, is it right?

If you want to use the release candidate, you need to use the
instructions for Rails Edge, except you replace

http://dev.rubyonrails.org/svn/rails/trunk

with
http://dev.rubyonrails.org/svn/rails/branches/1-2-pre-release

Hope that helps !

François Beausoleil
http://blog.teksol.info/
http://piston.rubyforge.org/