Question about loop testing usrp


#1

Hi,

I am trying to run siggen-oscope test using the “A” board for the
siggen and the “B” board for the oscope.

I use the command usrp_oscope.py --rx-subdev=A to specify the board
side, but this does not work. Could someone please help me to correct
my command?

The other problem I have is that if I have a physical signal
generator, and I wire up this signal generator to RX of A, and then
the signal analyzer to the TX/RX of B. How can I run this loop thise?
What python file can I run?

Thanks alot for your help.

Pete


#2

On Wed, Mar 18, 2009 at 11:39:00AM +0800, Pete Kay wrote:

generator, and I wire up this signal generator to RX of A, and then
the signal analyzer to the TX/RX of B. How can I run this loop thise?
What python file can I run?

Thanks alot for your help.

Pete

Pete,

You’re not giving us much to work with here.

Can you please take a look at this page, then try again?

http://gnuradio.org/trac/wiki/ReportingErrors

Eric