Problems after replacing the F501 fuse

GNU Radio
1

Hi.

After blowing up and replacing the F501 fuse the USRP is found by the
computer but it doesn’t give me any signal. The usrp_fft.py-window is
emty accompanied with the error message “Faild to set initial frequency”
and the benchmark stops working at 2MB/s. We believe the ADC is damaged.
Is there anyone out there with similar problems or a solution?

2

On Sat, Mar 15, 2008 at 02:52:32PM +0100, Staffan J. wrote:

Hi.

After blowing up and replacing the F501 fuse the USRP is found by the
computer but it doesn’t give me any signal. The usrp_fft.py-window is
emty accompanied with the error message “Faild to set initial frequency”
and the benchmark stops working at 2MB/s. We believe the ADC is damaged.
Is there anyone out there with similar problems or a solution?

“Failed to set initial frequency” usually means that you asked a
daughterboard to tune out of it’s range.

If you want to specify 92 MHz, use -f 92M, not -f 92

Eric