Hi Everyone,
I’m studying at the University of Witwatersrand in Johannesburg, South
Africa and we received a set of four USRP2s about 5-6 months ago. I
immediately unpacked two of them and after a few hiccups, got them
working. Two days ago, I needed to make use of the other two USRP2s and
the second one doesn’t seem to work. All that happens when I plug it in
is that the ‘d’ LED lights up. I’ve tried swapping the Flash Card (i.e.
firmware) and the daughter boards (in case there’s a hardware fault) and
nothing changes.
I’m seriously hoping this problem is fixable. Can anybody please provide
me with some guidance.
Kind regards,
Ryan van den Bergh
–
Ryan van den Bergh
PhD Candidate
Centre for Telecommunications Access and Services
School of Electrical and Information Engineering, University of the
Witwatersrand
E-Mail: [email protected]
Cell: +27 83 353 9600
Work: +27 11 717 7225
This communication is intended for the addressee only. It is
confidential. If you have received this communication in error, please
notify the author immediately and destroy the original message. You may
not copy or disseminate this communication without the permission of the
author.