PROBLEM: HOWTO.i EXAMPLE

I have a problem recompiling the howto example on “how to make a signal
processing block” webpage.
This is the website should you be interested:

http://www.gnu.org/software/gnuradio/doc/howto-write-a-block.html

I ran aclocal, autoconf, then auotomake.

However, everytime I run automake the following error messages are
displayed:

[email protected]:~/gr-howto-write-a-block-3.1.1$ sudo make
make all-recursive
make[1]: Entering directory
/home/jpgacrama/gr-howto-write-a-block-3.1.1' Making all in config make[2]: Entering directory/home/jpgacrama/gr-howto-write-a-block-3.1.1
/config’
make[2]: Nothing to be done for all'. make[2]: Leaving directory/home/jpgacrama/gr-howto-write-a-block-3.1.1
/config’
Making all in src
make[2]: Entering directory
/home/jpgacrama/gr-howto-write-a-block-3.1.1 /src' Making all in lib make[3]: Entering directory/home/jpgacrama/gr-howto-write-a-block-3.1.1
/src/lib’
make[3]: *** No rule to make target /swig/gnuradio.i', needed byhowto.cc’. Stop.
make[3]: Leaving directory /home/jpgacrama/gr-howto-write-a-block-3.1.1 /src/lib' make[2]: *** [all-recursive] Error 1 make[2]: Leaving directory/home/jpgacrama/gr-howto-write-a-block-3.1.1
/src’
make[1]: *** [all-recursive] Error 1
make[1]: Leaving directory
`/home/jpgacrama/gr-howto-write-a-block-3.1.1’
make: *** [all] Error 2

It keeps on saying that there is “No rule to make target
/swig/gnuradio.i', needed byhowto.cc’. Stop.”

What’s the problem here? I really need a reply ASAP! I really need this
for
my thesis. Thanks!

On Sun, Jan 06, 2008 at 10:18:05AM +0800, Jonas Gacrama wrote:

I have a problem recompiling the howto example on “how to make a signal
processing block” webpage.
This is the website should you be interested:

http://www.gnu.org/software/gnuradio/doc/howto-write-a-block.html

I ran aclocal, autoconf, then auotomake.

However, everytime I run automake the following error messages are
displayed:

  1. Did you build and install GNU Radio? Does it pass “make check”?
  2. Does your --prefix path contain spaces, or does the path to your
    build directory contain spaces? If so, change to paths without
    spaces.

Eric

This forum is not affiliated to the Ruby language, Ruby on Rails framework, nor any Ruby applications discussed here.

| Privacy Policy | Terms of Service | Remote Ruby Jobs