# Noisy source block

higuys
why the unit of amplitude in Noisy source block is volt?
how to explain this ?
thanks,
BZS

On 04/15/2014 04:46 AM, 猪猪猪猪猪猪头 wrote:

hi，guys
why the unit of amplitude in Noisy source block is volt?
how to explain this ?
thanks,
BZS

Not sure what your question is. Signal amplitudes are usually in Volts,
that’s just the right physical unit.

I assume you’re asking because in the digital domain, there’s really no
volts, and that’s a good point. The unit could also just be 1. This is
something you sometimes see in (especially older) DSP textbooks.

There’s a similar thing, where the mag-square of a signal is often
considered its instantaneous power (which, would assume a resistance of
1 \Ohm if you’re still thinking in physical power).

So, just ignore this if it confuses you.

Martin

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

Hi 猪猪猪猪猪猪头,

you’ve replied to the wrong thread; however:

dB is always a relative measure. You can’t output dB; it always has
to be dB in relation to something.

The parameter of the noise source is amplitude.
Like Martin, if I want to stick a physical entity to it, it would be
voltage. Usually, I don’t – the noise source just outputs a
realization of a complex random process; it’s just numbers without unit.

I’m under the impression you’re mixing up absolute noise power, noise
variance, and SNR; for SNR, which is a ratio, dB does indeed make
sense. However, you don’t get a noise source that generates a certain
SNR, because that depends on the signal power, and is something that

Greetings,
Marcus

hi ,Martin B. well ,in my impression, the unit of is noisy is
dB,so i feel fuzzy