(no subject)

I am confused about the terms full duplex and half duplex in context of
USRP…If i am using two antennas attached on the same channel on
B210(one
on TX/RX and other on RX2).I am Rxing through one antenna and
retransmitting the signal with the other antenna…Am i operating on full
duplex or half duplex??

Full duplex implies simultaneous transmission and reception, almost
always
on different frequencies. In the cellular world this is called
frequency
division duplexing, or FDD. Full duplex on a USRP implies transmitting
on
one connector (TX/RX) and receiving on the other (RX2).

Half duplex means you never TX and RX simultaneously.

Matt

Thank you Matt!

This forum is not affiliated to the Ruby language, Ruby on Rails framework, nor any Ruby applications discussed here.

| Privacy Policy | Terms of Service | Remote Ruby Jobs