Hi,
I am using WX GUI Scope Sink, and I have set the sample rate = 1M, same
as the USRP. It seems that a minimum number of data points are required
before anything appears on the plot - is that correct, and how can it be
adjusted?
Also, I am looking at constellations, using the XY mode to show real and
imaginary. It is possible to have multiple inputs, but is it possible to
view multiple ‘series’ in XY mode?
I seem to be only able to choose Ch X vs Ch Y, e.g. Ch 1 vs. Ch 2 (
Re(in1) vs. Im(in1) ) or Ch 1 vs. Ch 4 (Re(in1) vs. Im(in2)). I would
like to see Ch 1 vs. Ch 2 and Ch 3 vs Ch 4 simultaneously?
Thanks in advance!
David
NOTE: The information in this email and any attachments may be
confidential and/or legally privileged. This message may be read, copied
and used only by the intended recipient. If you are not the intended
recipient, please destroy this message, delete any copies held on your
system and notify the sender immediately.
Toshiba Research Europe Limited, registered in England and Wales
(2519556). Registered Office 208 Cambridge Science Park, Milton Road,
Cambridge CB4 0GZ, England. Web: www.toshiba.eu/research/trl
Scanned by MailDefender - managed email security from intY -
www.maildefender.net