There doesn’t seem to be a whole lot of documentation on M-Blocks. The
main bits I’ve found so far are the wiki page, and of course looking
through the source.
A couple of questions: on M-block support for the USRP2: I’ve seen a
couple comments that this is/should be available, but I’m not clear on
how this is to be done. With the usrp this relied on the usrp_server
code - is there a similar server for the usrp2?
Doug
–
Doug G.
Research Assistant
Communications and Signal Processing Lab
Oklahoma State University
http://cspl.okstate.edu
[email protected]
[email protected]
On Mon, Dec 15, 2008 at 1:58 PM, Douglas G.
[email protected] wrote:
A couple of questions: on M-block support for the USRP2: I’ve seen a
couple comments that this is/should be available, but I’m not clear on
how this is to be done. With the usrp this relied on the usrp_server
code - is there a similar server for the usrp2?
There is not mblock support for the USRP2 right now, though the
ability to send and receive at particular times exists in the
low-level libusrp2 interface.
We are in the middle of deciding the future direction of the mblock
library (see the list archives for several recent emails where I’ve
elaborated on this), so until we close on that issue, we’ll hold off
on doing development that we might need to rewrite later.
-Johnathan