Hi,
I unluckily formatted the SD card given with USRP2 package.
Now I am not knowing where to start.I have to use Matlab with USRP2.
I went through the forums and I found that through UHD one can make the
USRP2 interact with GNURadio,Labview,Matlab.For this UHD needed to be
burnt
on the SD card.
Hence i downloaded it through the following link
git clone git://code.ettus.com/ettus/uhd.git
It said “initialized empty Git repository in /home/cogwsn/uhd/.git/”
After that i checked that folder named uhd.
There were four sub-folders in side that folder named
firmware,fpga,host,imaes and a file also named fix-copyright-years.
My question is that shall I burn all of them to the SD card using the
command
sudo /share/uhd/utils/usrp2_card_burner_gui.py
1.If no then what has to be burnt and how.
2.If yes then I actually tried the above command but the GUI which
popped
out gives option to select the firmware and fpga images only.
I already have downloaded the firmware and fpga images from the link
http://code.ettus.com/redmine/ettus/projects/public/wiki/U2binaries
The fpga image file is —>>>>Raw Ethernet rel-20100603 d488c6b2
June 3,
2010
and the firmware image file is — >>>> Raw Ethernet, with XCVR2450
v3.3.1git Jun 08, 2010
I have XCVR2450 daughter board with me and I am using ubuntu10.10.
I have landed in a total confusion.Wish i could havn’t formatted the
card 
I will appreciate very much if someone will tell me a step by step
approach.
(I am a windows guy and this ubuntu is giving a lot of pain )
I am desperate to run my code and transmit data through USRP2 but since
2
days I am not even able to make the device working.
Sumit Kr.
Research Assistant
Communication Research center
IIIT Hyderabad
India
View this message in context:
http://old.nabble.com/Issues-in-burning-UHD-images-into-SD-card.-tp31582897p31582897.html
Sent from the GnuRadio mailing list archive at Nabble.com.