Info regarding full duplex operation of RFX2400

Hi,

I have question regarding the full duplex operation of RFX2400 board.
Looking at the circuit diagram of the board, I understand that each
RFX2400
board has seperate receive AND transmit chain. Hence, if I connect one
antenna to “RX” port and another different antenna to “TX/RX” port and
use
this system to make full duplex transceiver, is it possible that
there
will be crosstalk between different RF components of RFX2400 board when
both
transmit/receive chains are operating at the same time. IF yes, how bad
is
its effect??

If someone can give me some insight into this, then it will be great.

Thanks,
Rohit


Discuss-gnuradio mailing list
[email protected]
http://lists.gnu.org/mailman/listinfo/discuss-gnuradio

Hi Greg,

Thanks.

What if I use “two” GNURAdio boards at the same time, one for TX and
another
for RX. However, they are now placed very close to each other(say
<10cm). Do
you think this will be a good idea to achieve isolation between TX and
RX
chains??

Rohit


Discuss-gnuradio mailing list
[email protected]
http://lists.gnu.org/mailman/listinfo/discuss-gnuradio