Implementation of ieee 802-11 transeiver


I would like to implement a transceiver in USRP E 110 with gnuradio.

For that I found a code concerning an implementation of ieee 802-11 of a
transeiver with USRP N 210 descibed in this
To implement it I followed the script “read me” mentionned in this link

But when I tried to install gnuradio 3.7 byPyBOMBS in this link

When I typed this command ./pybombs install gnuradio it works.

But when I typed this command [email protected]:~/pybombs$ source

it shows me this:
bash: / No such file or directory
[email protected]:~/pybombs$

plz how to deal with this error.

In fact, when I typed /pybombs install gnuradio it asks me to enter
and other staffs

I have just typed enter when it asked me to put these variables. is this
can harm .

what sall I do to correct this error

thanks a lot,

it shows me this [email protected]:~/pybombs$ ./pybombs env
Settled on prefix: /home/wafa/target
Initializing environmental variables…
---------- loading recipes -------------------
Loading recipes …
Loading recipes … done
---------- loading recipes finished ----------

Writing out env…:
PyBombs.sysutils - INFO - To set up your environment (in bash) run:
[email protected]:~/pybombs$ source /home/wafa/target
bash: source: /home/wafa/target: is a directory
[email protected]:~/pybombs$ /

is this mean that is ok ?

2014-05-10 19:43 GMT+02:00 Kiran K. [email protected]:

sorry this message is shown

[email protected]:~/pybombs$ source /home/wafa/target/
[email protected]:~/pybombs$

2014-05-10 19:53 GMT+02:00 Wafa E. [email protected]:

You have a line break there accidentally, it should be on one line.

If you run:

echo “source /home/wafa/target/” >> ~/.bashrc

Then this will add the line to the end of your .bashrc startup file.

Then type:

source ~/.bashrc

…which will then activate it.


Email: [email protected]

On Sat, May 10, 2014 at 6:53 PM, Wafa E.
<[email protected]

I typed these commands
[email protected]:~/pybombs$ source /home/wafa/target/
[email protected]:~/pybombs$ echo “source /home/wafa/target/”

[email protected]:~/pybombs$ source ~/.bashrc

plz what shall I do now to have gnuradio 3.7

2014-05-10 19:59 GMT+02:00 Mike J. [email protected]:

cross your fingers and run gnuradio-companion at the command prompt :slight_smile:

Email: [email protected]

On Sat, May 10, 2014 at 7:06 PM, Wafa E.
<[email protected]

This forum is not affiliated to the Ruby language, Ruby on Rails framework, nor any Ruby applications discussed here.

| Privacy Policy | Terms of Service | Remote Ruby Jobs