I recently updated the USRP2 firmware to txrx_wbx_UDP_20100507.bin from
I also downloaded and installed u2_rev3-udp-ise12-20100615.bin from the
These images are specifically designed for WBX with UDP. After putting
SD card into the USRP2, I’ve tried pinging the USRP2, the process ending
unsuccessfully, which I’ve read somewhere it’s expected since it doesn’t
have a fully implemented IP stack. But it doesn’t reply to “find_usrps”
“benchmark_tx” nor “usrp2_probe”.
How can I test to see if the firmware and fpga images are actually
functioning and the board is operating properly?
I am pretty stuck with this and would really appreciate any useful
View this message in context:
Sent from the GnuRadio mailing list archive at Nabble.com.