Gr-radar-mono file output

I just had a question regarding the log file this program produces. As
far as I can tell, the samples are of the type gr-complex. I’ve tried
using the file reading matlab script provided in the utils folder, but I
can’t arrange and display the data in a meaningful way. Could someone
perhaps provide some guidance on the correct way to read and display the
data from the echo output file produced by the gr-radar code?

Regards

Lance

On Sun, Mar 1, 2009 at 2:27 PM, Lance [email protected] wrote:

I just had a question regarding the log file this program produces. As far
as I can tell, the samples are of the type gr-complex. I’ve tried using the
file reading matlab script provided in the utils folder, but I can’t arrange
and display the data in a meaningful way. Could someone perhaps provide some
guidance on the correct way to read and display the data from the echo
output file produced by the gr-radar code?

The output file is as you describe, a concatenated series of complex
baseband echos corresponding to the samples received during the
configured range gate. The sample rate will be 64 Msps; you will need
to determine how many samples there are per echo based on your
configuration parameters. I believe the script in verbose mode will
print this out, but I’d have to go check.

Johnathan

This forum is not affiliated to the Ruby language, Ruby on Rails framework, nor any Ruby applications discussed here.

| Privacy Policy | Terms of Service | Remote Ruby Jobs