Hi ,
I am new to GNU Radio and am facing difficulties in implementing DQPSK
modulation on Gnu Radio Companion. The system works fine , but for one
small
glitch. The DQPSK modulator/demodulator’s input and output are in Byte
format, which makes it a little hard to comprehend the output.
for eg : if the input is 00100001.
The o/p of the demod is as follows : 00000000 00000000 11111111
00000000 00000000 00000000 00000000 11111111 (instead of 00100001).
I would be really grateful if a way around this can be told.
Kind Regards
Varun Krishnamurthy
MS ECE
Georgia Tech.
On Sun, Feb 6, 2011 at 1:34 PM, Varun Krishnamurthy <
[email protected]> wrote:
The o/p of the demod is as follows : 00000000 00000000 11111111
00000000 00000000 00000000 00000000 11111111 (instead of 00100001).
I would be really grateful if a way around this can be told.
Kind Regards
Varun Krishnamurthy
MS ECE
Georgia Tech.
I believe this is what the block unpacked_to_packed is for.
On Sun, Feb 06, 2011 at 01:58:17PM -0500, Steven C. wrote:
for eg : if the input is 00100001.
The o/p of the demod is as follows : 00000000 00000000 11111111
00000000 00000000 00000000 00000000 11111111 (instead of 00100001).
I would be really grateful if a way around this can be told.
I believe this is what the block unpacked_to_packed is for.
Also, you should check why your demod outputs eight 1’s instead of one.
And don’t forget to include a preamble or something like that in your
transmission, otherwise you won’t be able to figure out which symbol
maps to which bit, and the packed bit stream will actually be less
informative than the unpacked one.
MB
–
Karlsruhe Institute of Technology (KIT)
Communications Engineering Lab (CEL)
Dipl.-Ing. Martin B.
Research Associate
Kaiserstraße 12
Building 05.01
76131 Karlsruhe
Phone: +49 721 608-43790
Fax: +49 721 608-46071
www.cel.kit.edu
KIT – University of the State of Baden-Württemberg and
National Laboratory of the Helmholtz Association