---------- Forwarded message ----------
From: Zongyi LIU [email protected]
Date: 2014-08-06 17:30 GMT+02:00
Subject: Re: [Discuss-gnuradio] Install UCLA-gr-802.15.4 into E100 has
error
To: Bastian B. [email protected]
Hi Bastian,
I have read your paper “A GNURadio-based IEEE 802.15.4 Testbed”. It’s
really an excellent job.
Your testbed implement from PHY layer up to network layer and run
Contiki
system. But, you implement them on N210 with a high performance.
So, I don’t know whether it’s possible to implement your code on E100?
As
you know, E100 use an embedded processor ARM Cortex-A8 with limited
computational and process ability, it runs special Angstrom linux
system.
I got some information from this paper “IEEE 802.15.4 Implementation on
an
Embedded Device”, it mentions that they can’t used UCLA-802.15.4 code to
receive packet. The embedded processor is not fast enough to demodulate
data. Finally, he redesign FPGA to pre-process some data before sending
them to processor and receive package barely…
So, Hope for your suggestion and thank you again!
Best
Zongyi
2014-08-06 9:59 GMT+02:00 Bastian B. [email protected]:
You could give this a try
Hello everyone:
//grincludedir = $(includedir)/gnuradio -I/usr/include/gnuradio
`/home/root/UCLA-gr-ieee802-15-4/gr-ieee802-15-4’
make[3]: Entering directory
-Woverloaded-virtual -pthread -MT ucla.lo -MD -MP -MF .deps/ucla.Tpo -c
make[2]: Leaving directoryYou’re problem is indeed that you don’t have the development package for
–
Dipl.-Inform. Bastian B.
Distributed Embedded Systems Group
University of Paderborn, Germany
Home | Bastian Bloessl
–
Zongyi LIU
Doctorant
Institut de Recherche en Informatique de Toulouse (IRIT)
Université Paul Sabatier, 118 Route de Narbonne, F-31062 TOULOUSE CEDEX
9
Email : [email protected]