On Thu, Feb 18, 2010 at 3:30 PM, Katherine [email protected]
wrote:
I’d also like to add that this only occurs for 1.9.2.
Using Ruby 1.9.1 and Ruby 1.8.7, installing rspec-rails and mail gem
is just fine.
Katherine, here are my results for installing rspec and rspec-rails:
$ ruby -v
ruby 1.9.2dev (2010-02-18 trunk 26707) [powerpc-darwin9.8.0]
$ gem install rspec rspec-rails
Thank you for installing rspec-1.3.0
Please be sure to read History.rdoc and Upgrade.rdoc
for useful information about this release.
Successfully installed rspec-1.3.0
Thank you for installing rspec-rails-1.3.2
If you are upgrading, do this in each of your rails apps
that you want to upgrade:
$ ruby script/generate rspec
Please be sure to read History.rdoc and Upgrade.rdoc
for useful information about this release.
Successfully installed rspec-rails-1.3.2
2 gems installed
Installing ri documentation for rspec-1.3.0…
Installing ri documentation for rspec-rails-1.3.2…
Installing RDoc documentation for rspec-1.3.0…
Could not find main page README.rdoc
Installing RDoc documentation for rspec-rails-1.3.2…
Could not find main page README.rdoc
If you’re using RVM to manage your Ruby VMs, then I would recommend
doing
the following:
rvm install ruby-head
Note: If it is installed already installed, then the above command
would
perform an ‘svn update’ and rebuild things as normal.
Ruby 1.9.2 development branch is very active. Thus, if you want to stay
current, then you’ll need to upgrade every so often. Lastly, I also
tend to
use Ruby 1.9.1 (i.e. rvm install 1.9.1-head) in conjunction with Ruby
1.9.2
because it’s a bit more stable and it’s a good fallback in the event
Ruby
1.9.2 source update goes bad. However, I can wait until Ruby 1.9.2 is
released because it appears noticeably faster than 1.9.1.
Good luck,
-Conrad