Enclosure setup

Matt,

In the enclosure_open picture, you show the fan in the position such
that it is blowing outside air in. Is this the correct configuration? I
thought devices usually blew hot air out.

Secondly, for the 8 mounting points around the edges (rather than the 4
corners/ 4 center), those are simply tightened on to the bottom of the
usrp board with nuts? This seems unstable; is there a way to configure
it such that they contact the base?

Thanks,

Dan

This forum is not affiliated to the Ruby language, Ruby on Rails framework, nor any Ruby applications discussed here.

| Privacy Policy | Terms of Service | Remote Ruby Jobs