Hello,
Well my first commit and I fell flat on my face. I committed the source
directory for the Mode Select code but not the actual source files.
This is fixed.
I am using the kdesvn tool which seems to work good once you figure out
the difference between the add and the add recursive commands. 
I need to adjust the padding of a structure to eliminate buffer
warnings. I noticed that sometimes it occurs on only one of several
machines I use. It seems like sometimes I make changes and I do not get
the buffer warnings until I do a make distclean then do a build.
The code will mot be merged into the trunk for awhile as I still need to
add things and fix things. I notice some problems with the good frame
only filter in the log formatter. I do not seem to get good short
frames other than type 11 from ACAS/TCAS interrogators.
73 Eric
I need to adjust the padding of a structure to eliminate buffer
warnings.
There really isn’t any need to get rid of the warnings unless you find
that it is a big performance hit, which is VERY unlikely.
I noticed that sometimes it occurs on only one of several
machines I use. It seems like sometimes I make changes and I do not get
the buffer warnings until I do a make distclean then do a build.
This, on the other hand, is a problem. You should get the same messages
every time you run.
Matt
Matt E. wrote:
This, on the other hand, is a problem. You should get the same messages
every time you run.
Matt
Hello,
I will look at it more.
Meanwhile I think my DBSRX board broke. I can not receive anything and
the Maxium chip gets pretty warm. The +5 Volt line at the electrolytic
cap measures 4.88 volts with 6.14 volt input at the power socket.
Any other points I can check?
73 Eric
