Daughter board pins

Hi. I’m trying to do some FPGA development on the USRP and would like
some information if anyone has it readily available.

I’d like to capture the output from the board (same data that goes to
the USB) from a daughterboard. I understand that I can do this by using
the pins on the BasicRX board. However, my oscilloscope did not pick up
any signals. Is there somewhere I need to tinker to get the output on
these pins? I’m tempted to do a dirty Verliog hack but I feel there must
be a clean way of doing this somewhere.

Thanks

Andrew

Andrew Borg wrote:

Hi. I’m trying to do some FPGA development on the USRP and would like
some information if anyone has it readily available.

I’d like to capture the output from the board (same data that goes to
the USB) from a daughterboard. I understand that I can do this by
using the pins on the BasicRX board. However, my oscilloscope did not
pick up any signals. Is there somewhere I need to tinker to get the
output on these pins? I’m tempted to do a dirty Verliog hack but I
feel there must be a clean way of doing this somewhere.

You’ll need to make some changes to the Verilog code, in the toplevel
module.

Matt