Clarification on RFX-2400

Hi,

I am using RFX2400 daughter board as a receiver in USRP. In the run
time, will I be able to use it as a transmitter? For ex, say the board
will act as a receiver for 30 seconds and switch to transmit mode after
30 secs automatically? Please help me, how would I do that in software.
I am using the antenna in the TX/RX SMA port.

Regards,

Sivaram

On Tue, Oct 20, 2009 at 12:01:20PM +0530, Narayanan,?Sivaramasubramanian
(R&T) wrote:

I am using RFX2400 daughter board as a receiver in USRP. In the run
time, will I be able to use it as a transmitter? For ex, say the board
will act as a receiver for 30 seconds and switch to transmit mode after
30 secs automatically? Please help me, how would I do that in software.
I am using the antenna in the TX/RX SMA port.

The feature’s called automatic Tx/Rx switching.
Many of the examples use it, check the tunnel.py scripts.

MB


Karlsruhe Institute of Technology (KIT)
Communications Engineering Lab (CEL)

Dipl.-Ing. Martin B.
PhD Student

Kaiserstraße 12
Building 05.01
76131 Karlsruhe

Phone: +49 721 608-3790
Fax: +49 721 608-6071
www.cel.kit.edu

KIT – University of the State of Baden-Württemberg and
National Research Center of the Helmholtz Association

This forum is not affiliated to the Ruby language, Ruby on Rails framework, nor any Ruby applications discussed here.

| Privacy Policy | Terms of Service | Remote Ruby Jobs