Change of daughter board

Hello all,

I have been using GNU radio with RFX2400 daughterboard (2.3 to 2.9 GHz).
I want to use WBX daughter board (50 MHz to 2.2 GHz).

What are the changes I have to make to my software
Do I have to burn new image to SD card of my usrp2.

Regards,
Umer Rabbani | Researcher

Polaris House, PP129 B29, Adastral Park, Ipswich, IP5 3RE
01473645887|  - 0743 57 67 821

Hello Umer,

You do not have to burn a new image to the SD card. The only reasons I
can
think of for burning a new SD image is if you were upgrading the
firmware
or modifying FPGA behavior. The only modification to your software
should
be to change the receiving frequency to one that falls in the range of
the
WBX board.

Take care,
Ryan Wolfarth

This forum is not affiliated to the Ruby language, Ruby on Rails framework, nor any Ruby applications discussed here.

| Privacy Policy | Terms of Service | Remote Ruby Jobs