Analog signal input

GNU Radio
1

I have 2 doubts.

  1. I input some data on the Rx-daughterboard. Now I want to digitize it
    and
    store it on the fpga, which I intend to use later with a verilog code of
    mine. How can I achieve this?

  2. I input some data on the Rx-daughterboard. Now I want to digitize it
    and
    send it to the fpga. Then I want to pass it through the DAC and output
    it
    back on the Tx-daughterboard and verify that the output is an exact
    replica
    of the input. How can I achieve this?

Thanks a lot.

Regards,
Kuntal

View this message in context:
http://www.nabble.com/analog-signal-input-tf3777043.html#a10680219
Sent from the GnuRadio mailing list archive at Nabble.com.

2

On Fri, May 18, 2007 at 04:14:33AM -0700, Kuntal wrote:

of the input. How can I achieve this?

Thanks a lot.

Regards,
Kuntal

Kuntal,

I suggest that the path to understanding in this matter is to look at
the existing verilog source code, understand how it works, and then
figure out how to proceed from there.

Your questions are very broad, which is perhaps why you haven’t
received an answer yet.

You should also take a look at the data sheet for the Cyclone FPGA,
and familiarize yourself with its memory capacity and how it’s
currently being used.

Eric