Adding block to an existing module

GNU Radio
1

Dear gnuradio list,

I have built a new module using the create-gnuradio-out-of-tree-project
command. Now I would like to add new blocks to this module. Writing new
.h, .cc and swig-files is not a problem, but obviously I have to adapt
some Makefiles etc.

I thought, it would be a good idea to take a look at the
howto-write-a-block structure and modify existing Makefiles. But I am
not familiar with these things and hope there is an easier way.

Could someone please tell me, what is the best way to add a signal
processing block to an existing module? At the moment I am only able to
create a new block creating a new module at the same time, which doesn’t
make much sense. I have searched the web a lot, maybe it is too trivial
to find any useful information…

I am currently running Ubuntu 10.04 with gnuradio 3.5.2.1.

Thanks in advance
Piotr

2

On Fri, May 25, 2012 at 01:48:55PM +0200, Piotr Palka wrote:

block to an existing module? At the moment I am only able to create a new block
creating a new module at the same time, which doesn’t make much sense. I have
searched the web a lot, maybe it is too trivial to find any useful information…

Using gr-modtool would be the easiest way.
(https://www.cgran.org/wiki/devtools).

And it’s not that hard to find.

MB

–
Karlsruhe Institute of Technology (KIT)
Communications Engineering Lab (CEL)

Dipl.-Ing. Martin B.
Research Associate

Kaiserstraße 12
Building 05.01
76131 Karlsruhe

Phone: +49 721 608-43790
Fax: +49 721 608-46071
www.cel.kit.edu

KIT – University of the State of Baden-Württemberg and
National Laboratory of the Helmholtz Association