well i have sorted out the issue. I was doing a mistake by putting ‘cd’
before the directory and then was trying to run the file after entering
the directory (gnuradio/usrp/host/apps). I should have written the
following in terminal instead:
gohar@ubuntu:~gnuradio/usrp/host/apps/burn-db-eeprom -t rfx900_mimo_a -f
-A -B
This works fine.
Gohar
gohar wrote:
I did all the modifications on rfx900.
when trying to burn eeprom i receive the following error.
bash: burn-db-eeprom: command not found
I am trying to run the command in the following manner (after mounting
the rfx900 on side A of USRP rev 3):
gohar@ubuntu:~/gnuradio/usrp/host/apps$burn-db-eeprom -t rfx900_mimo_a
-f -A -B
What am i missing?
Is there any problem with the permissions? If yes, then how to set
permissions correctly?
Gohar
The newer way will have better phase noise.
Matt