# Help to Test DBSRX and USRP

**URL:** <https://www.ruby-forum.com/t/help-to-test-dbsrx-and-usrp/159312>\
**Category:** GNU Radio\
**Created:** [February 3, 2009, 12:18pm UTC](https://www.ruby-forum.com/t/help-to-test-dbsrx-and-usrp/159312 "2009-02-03T12:18:24Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![JosSSSS\_Carlos\_R](https://www.ruby-forum.com/letter_avatar_proxy/v4/letter/j/5daacb/32.png) [@JosSSSS\_Carlos\_R](https://www.ruby-forum.com/u/JosSSSS_Carlos_R)\
**Post date:** [February 3, 2009, 12:18pm UTC](https://www.ruby-forum.com/t/help-to-test-dbsrx-and-usrp/159312/1 "2009-02-03T12:18:24Z")

</div>

Hi all,

As I posted before, after installing Gnu Radio (3.1.3 tarball) I tested  
my  
USRP and Dbsrx daughterboard when usrp\_fft.py and I could see gsm  
spectrum  
without problems. After that, I installed Tvoid to decode gsm channels  
and  
it worked. Now, I do not know what happend. When I type something like:

./usrp\_fft.py -R A -d 64 -g 20

show me the sprectrum like noise ( I have seen the whole band - 800-  
2400Mhz  
like noise at the same level).  
My dbsrx is in slot A. Besides, Tvoid does not work right now. My USRP  
does  
not receive from the RF.

What could be happening?  
Is there any way to test dbsrx?  
Was able to change the configuration of the FPGA? I do not think so.

Thanks in advance.  
Sincerely,

Jose

---

<div class="post-metadata">

**Author:** ![JosSSSS\_Carlos\_R](https://www.ruby-forum.com/letter_avatar_proxy/v4/letter/j/5daacb/32.png) [@JosSSSS\_Carlos\_R](https://www.ruby-forum.com/u/JosSSSS_Carlos_R)\
**Post date:** [February 3, 2009, 7:07pm UTC](https://www.ruby-forum.com/t/help-to-test-dbsrx-and-usrp/159312/2 "2009-02-03T19:07:28Z")

</div>

Hi all,

Is it possible to do a reset at USRP?

Thanks,

Jose

2009/2/3 JosÃ© Carlos R. [removed\_email\_address@domain.invalid](mailto:removed_email_address@domain.invalid)
