# Gem install error

**URL:** <https://www.ruby-forum.com/t/gem-install-error/49516>\
**Category:** Ruby\
**Created:** [December 5, 2005, 5:45pm UTC](https://www.ruby-forum.com/t/gem-install-error/49516 "2005-12-05T17:45:43Z")\
**Posts on this page:** 8\
**Page:** 1

<div class="post-metadata">

**Author:** ![transfire](https://www.ruby-forum.com/letter_avatar_proxy/v4/letter/t/c67d28/32.png) [@transfire](https://www.ruby-forum.com/u/transfire)\
**Post date:** [December 5, 2005, 5:45pm UTC](https://www.ruby-forum.com/t/gem-install-error/49516/1 "2005-12-05T17:45:43Z")

</div>

trans@ubixie:/usr/local/lib/site\_ruby/1.8$ sudo gem install  
calibre-basicobject  
Password:  
Attempting local installation of ‘calibre-basicobject’  
Local gem file not found: calibre-basicobject\*.gem  
Attempting remote installation of ‘calibre-basicobject’  
ERROR: While executing gem … (OpenURI::HTTPError)  
404

Any ideas?

T.

---

<div class="post-metadata">

**Author:** ![transfire](https://www.ruby-forum.com/letter_avatar_proxy/v4/letter/t/c67d28/32.png) [@transfire](https://www.ruby-forum.com/u/transfire)\
**Post date:** [December 5, 2005, 5:57pm UTC](https://www.ruby-forum.com/t/gem-install-error/49516/2 "2005-12-05T17:57:58Z")

</div>

> trans@ubixie:/usr/local/lib/site\_ruby/1.8$ sudo gem install  
> calibre-basicobject  
> Password:  
> Attempting local installation of ‘calibre-basicobject’  
> Local gem file not found: calibre-basicobject\*.gem  
> Attempting remote installation of ‘calibre-basicobject’  
> ERROR: While executing gem … (OpenURI::HTTPError)  
> 404

Hm, I was able to install it just now… perhaps the mirror was down for  
a moment or two… are you able to install it now?

Yours,

Tom

---

<div class="post-metadata">

**Author:** ![transfire](https://www.ruby-forum.com/letter_avatar_proxy/v4/letter/t/c67d28/32.png) [@transfire](https://www.ruby-forum.com/u/transfire)\
**Post date:** [December 5, 2005, 6:10pm UTC](https://www.ruby-forum.com/t/gem-install-error/49516/3 "2005-12-05T18:10:33Z")

</div>

On Mon, 05 Dec 2005 16:54:18 -0000, Tom C. [removed\_email\_address@domain.invalid](mailto:removed_email_address@domain.invalid)  
wrote:

> a moment or two… are you able to install it now?
> 
> Yours,
> 
> Tom

(not complaining!)

I’ve seen this on a few gems over the past few days, too, on several  
Gems.  
I just got the same error as above, then immediately reissued the  
command  
and got calibre-basicobject-1.0.0 (+ facets-2005.10.30) installed. I’d  
say  
it happened roughly one in four times I used Gems over the past week,  
but  
only once persisted for more than a moment.

I wonder if one of the mirrors has lost some files or something (with it  
being a 404) ?

---

<div class="post-metadata">

**Author:** ![transfire](https://www.ruby-forum.com/letter_avatar_proxy/v4/letter/t/c67d28/32.png) [@transfire](https://www.ruby-forum.com/u/transfire)\
**Post date:** [December 5, 2005, 6:47pm UTC](https://www.ruby-forum.com/t/gem-install-error/49516/4 "2005-12-05T18:47:42Z")

</div>

On Mon, 05 Dec 2005 16:58:45 -0000, I somehow managed to post:

> I’ve seen this on a few gems over the past few days, too, on several  
> Gems.

I’m not actually drunk, I just sound it.

---

<div class="post-metadata">

**Author:** ![transfire](https://www.ruby-forum.com/letter_avatar_proxy/v4/letter/t/c67d28/32.png) [@transfire](https://www.ruby-forum.com/u/transfire)\
**Post date:** [December 5, 2005, 6:39pm UTC](https://www.ruby-forum.com/t/gem-install-error/49516/5 "2005-12-05T18:39:16Z")

</div>

Okay, I tried it three more time (after the three before) and it  
finally worked. Hope you can figure out the issue and fix, it’s rather  
irksome.

Thanks,  
T.

---

<div class="post-metadata">

**Author:** ![transfire](https://www.ruby-forum.com/letter_avatar_proxy/v4/letter/t/c67d28/32.png) [@transfire](https://www.ruby-forum.com/u/transfire)\
**Post date:** [December 5, 2005, 6:47pm UTC](https://www.ruby-forum.com/t/gem-install-error/49516/6 "2005-12-05T18:47:42Z")

</div>

> Okay, I tried it three more time (after the three before) and  
> it finally worked.

Super!

> Hope you can figure out the issue and fix,  
> it’s rather irksome.

Hm, maybe I need to set up some sort of mirror monitoring thingy…

Yours,

Tom

---

<div class="post-metadata">

**Author:** ![transfire](https://www.ruby-forum.com/letter_avatar_proxy/v4/letter/t/c67d28/32.png) [@transfire](https://www.ruby-forum.com/u/transfire)\
**Post date:** [December 6, 2005, 5:50am UTC](https://www.ruby-forum.com/t/gem-install-error/49516/7 "2005-12-06T05:50:46Z")

</div>

In article [00da01c5f9c4$a6f3f800$0301a8c0@TOMHP](mailto:00da01c5f9c4$a6f3f800$0301a8c0@TOMHP),  
“Tom C.” [removed\_email\_address@domain.invalid](mailto:removed_email_address@domain.invalid) wrote:

> > I wonder if one of the mirrors has lost some files or  
> > something (with it  
> > being a 404) ?
> 
> It’s odd… because the files are just rsync’d from one machine to  
> another and then a mirror is selected via a RewriteMap [1]. I just  
> manually hit all the mirrors and they seem to be fine… but something  
> must be going awry somewhere.

Oddly, I just got a 300 Error

[jpb@athena:~/src]$ sudo gem update  
Password:  
Upgrading installed gems…  
Attempting remote upgrade of gruff  
Attempting remote installation of ‘gruff’  
ERROR: While executing gem … (OpenURI::HTTPError)  
300 Multiple Choices  
10.67 real 4.17 user 0.35 sys  
[jpb@athena:~/src]$

This happened both while I was out using T-Mobile’s network and at home  
with Time-Warner cable.

jpb

–  
Joe B. [removed\_email\_address@domain.invalid](mailto:removed_email_address@domain.invalid)

Have GNU, will travel.

---

<div class="post-metadata">

**Author:** ![transfire](https://www.ruby-forum.com/letter_avatar_proxy/v4/letter/t/c67d28/32.png) [@transfire](https://www.ruby-forum.com/u/transfire)\
**Post date:** [December 5, 2005, 6:55pm UTC](https://www.ruby-forum.com/t/gem-install-error/49516/8 "2005-12-05T18:55:49Z")

</div>

> I wonder if one of the mirrors has lost some files or  
> something (with it  
> being a 404) ?

It’s odd… because the files are just rsync’d from one machine to  
another and then a mirror is selected via a RewriteMap [1]. I just  
manually hit all the mirrors and they seem to be fine… but something  
must be going awry somewhere.

Anyhow, thanks for the additional data!

Yours,

Tom

[1]  
[http://tomcopeland.blogs.com/juniordeveloper/2005/11/faster\_rubyforg.htm](http://tomcopeland.blogs.com/juniordeveloper/2005/11/faster_rubyforg.htm)  
l
