# Fwd: My SRP - Problem deciding on the RF Front End design

**URL:** <https://www.ruby-forum.com/t/fwd-my-srp-problem-deciding-on-the-rf-front-end-design/112739>\
**Category:** GNU Radio\
**Created:** [August 22, 2007, 7:21pm UTC](https://www.ruby-forum.com/t/fwd-my-srp-problem-deciding-on-the-rf-front-end-design/112739 "2007-08-22T19:21:57Z")\
**Posts on this page:** 1\
**Page:** 1

<div class="post-metadata">

**Author:** ![Prasanna\_R](https://www.ruby-forum.com/letter_avatar_proxy/v4/letter/p/ed655f/32.png) [@Prasanna\_R](https://www.ruby-forum.com/u/Prasanna_R)\
**Post date:** [August 22, 2007, 7:21pm UTC](https://www.ruby-forum.com/t/fwd-my-srp-problem-deciding-on-the-rf-front-end-design/112739/1 "2007-08-22T19:21:57Z")

</div>

---------- Forwarded message ----------  
From: Prasanna R. [removed\_email\_address@domain.invalid](mailto:removed_email_address@domain.invalid)  
Date: Aug 22, 2007 10:49 PM  
Subject: Re: [Discuss-gnuradio] My SRP - Problem deciding on the RF  
Front  
End design… need help.  
To: Chris Albertson [removed\_email\_address@domain.invalid](mailto:removed_email_address@domain.invalid)

Hello Chris,

Firstly I thank for your sincere advice…

Microtune devices seem to have a high IF at around 25+ MHz which far  
too  
much for my requirement. Do they provide lower-IF devices…? i gues they  
do,  
but cant find locate them on their site.

As for the ADC output, I would be using a DDC to down-convert the  
samples  
to the baseband spectrum. By that way I can have just one common IF at  
say  
10 MHz for various types of information channels including FM AM audio.  
But  
yes, the fast data stream required in processing TV signals may need a  
UDP-like mode of data transfer…

A small doubt I have here is, can I use the cable TV device to  
downconvert  
audio AM-FM channels? I guess we can… kindly advice…

Regards,  
Prasanna
