# Err messages during make install-doc **URL:** \ **Category:** Ruby\ **Created:** [January 31, 2009, 7:55am UTC](https://www.ruby-forum.com/t/err-messages-during-make-install-doc/159074 "2009-01-31T07:55:52Z")\ **Posts on this page:** 1\ **Page:** 1
**Author:** ![mark](https://www.ruby-forum.com/letter_avatar_proxy/v4/letter/m/e9c0ed/32.png) [@mark](https://www.ruby-forum.com/u/mark)\ **Post date:** [January 31, 2009, 7:55am UTC](https://www.ruby-forum.com/t/err-messages-during-make-install-doc/159074/1 "2009-01-31T07:55:52Z")
I’m installing ruby for the first time on OS X 10.4.11. I’m following the directions written in Simply Rails 2, the section on install Ruby on a Mac. I installed readline, then I followed the directions for installing ruby 1.8.6. I ran “sudo make install” - no errors. When I ran “make install-doc”, I get the following errors: No definition for proc\_getpgrp … random.c: … range.c: c… re.c: ccc… regex.c: ruby.c: signal.c: m… No definition for interrupt\_init . sprintf.c: followed later by these errors: socket.c: ccccccccccm. No definition for bsock\_do\_not\_rev\_lookup . No definition for bsock\_do\_not\_rev\_lookup\_set . No definition for bsock\_s\_for\_fd . No definition for bsock\_close\_read . No definition for bsock\_close\_write . No definition for bsock\_shutdown … No definition for bsock\_getsockname . No definition for bsock\_getpeername . No definition for bsock\_send . No definition for bsock\_recv … No definition for ip\_addr . No definition for ip\_peeraddr . No definition for ip\_recvfrom . No definition for ip\_s\_getaddress … No definition for socks\_init . No definition for socks\_s\_close . No definition for tcp\_accept … No definition for tcp\_sysaccept . No definition for tcp\_svr\_init … No definition for udp\_init . No definition for udp\_connect . No definition for udp\_bind . No definition for udp\_send … No definition for unix\_init . No definition for unix\_path . No definition for unix\_addr . No definition for unix\_peeraddr . No definition for unix\_recvfrom . No definition for unix\_send\_io . No definition for unix\_recv\_io . No definition for unix\_s\_socketpair . No definition for unix\_s\_socketpair . No definition for unix\_svr\_init . No definition for unix\_accept … No definition for unix\_sysaccept … No definition for sock\_initialize … No definition for sock\_s\_socketpair . No definition for sock\_s\_socketpair . No definition for sock\_gethostname … No definition for sock\_s\_gethostbyaddr … No definition for sock\_s\_getnameinfo . No definition for sock\_s\_pack\_sockaddr\_in . No definition for sock\_s\_pack\_sockaddr\_in . No definition for sock\_s\_unpack\_sockaddr\_in . No definition for sock\_s\_pack\_sockaddr\_un . No definition for sock\_s\_pack\_sockaddr\_un . No definition for sock\_s\_unpack\_sockaddr\_un stringio.c: c… Running the command “ruby -v” tells me I’ve got version 1.8.6. But, should I be worried about these errors?